Common Mistakes in Hot Water Heater Installation

A new water heater installation in Lone Tree, CO can be just what your home needs to finally get consistent warm water flowing through the pipes again. It is recommended that this work be handled by certified professionals. You do not want to attempt it on your own because it is far too easy to make a mistake.

Incorrectly Installing the T&P Tube

The temperature and pressure tube should be fixed onto every water heater to prevent the tank from leaking in the event there is too much water. If it is left off entirely or not properly installed, then there is the possibility scalding how water can leak. This is not safe to the individuals in your household, and the leaking can damage the area of your house the heater is located in.

Not Strapping the Heater

An important part of any water heater installation in an area that tends to get earthquakes is remembering to strap it to a nearby frame. You do not want to risk the water heater tipping over because it could crack and leak. You may need to replace the entire unit if you forget to strap it, and it becomes damaged beyond repair.

Improperly Making Solder Connections

Your new water heater needs to be correctly connected to the house’s water pipes. The solders need to be a reasonably distance away from the heater so that they do not melt or wear down. If you have never installed a water heater before, then it is difficult to gauge where exactly the solders needs to be.

Although it can be tempting to make your next water heater installation a DIY project, it is always preferable to leave this work to the experts. That way you can relax with the knowledge a professional is handling everything. Additionally, installing water heaters can be dangerous if you do not know what you are doing, but experts know what precautions to take.

Be the first to like.

Leave a Reply

Your email address will not be published. Required fields are marked *

fifteen − two =